door06 .pdf

File information


Original filename: door06.pdf
Title: file://C:\Users\Vincent\Repair Manual\Civic 06 4d\A00\HTML\00\S
Author: Vincent

This PDF 1.3 document has been generated by PScript5.dll Version 5.2.2 / GPL Ghostscript 8.64, and has been sent on pdf-archive.com on 03/04/2011 at 00:17, from IP address 96.20.x.x. The current document download page has been viewed 1116 times.
File size: 59 KB (9 pages).
Privacy: public file


Download original PDF file


door06.pdf (PDF, 59 KB)


Share on social networks



Link to this file download page



Document preview


Front Door Outer Handle Replacement - Without Super Locking

Page 1 sur 9

Front Door Outer Handle Replacement - Without Super
Locking
Without Super Locking
NOTE: Put on gloves to protect your hands.
1. Raise the glass fully.

2. Remove the door panel and inner handle.

3. Disconnect the power door lock actuator connector (A).

C
B

B

A

4. Remove the plug caps (B), then remove the plastic cover (C), as needed.

5. Detach the rod fastener (A).

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 2 sur 9

A

6. Remove the maintenance cap (A). With a clip remover, disconnect the outer handle rod (B).

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 3 sur 9

A

B

7. Driver's and some passenger's: Pull both side flanges (A) of the retainer (B) outward, and pull the
middle flange portion (C) of the outer casing cover (D) out, then disconnect the cylinder cable (E)
from the latch.

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 4 sur 9

E

B

E

A

D
C

B
A

8. Remove the bolt, then remove the spacer (A).

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 5 sur 9

Fastener Location
: Bolt, 1

A

6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)

9. Remove the bolt securing the outer handle protector (A), then remove the protector by releasing
the hook (B).

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 6 sur 9

Fastener Location
: Bolt, 1

6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)

A
B
A

10. If necessary, remove the special screws, then separate the door cylinder (A) and outer handle
protector (B). If the retainer (C) is damaged, release the hooks (D), and replace it.
NOTE: If removed, the special screws must be replaced.

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 7 sur 9

Fastener Locations
: Screw, 2

B

A

C
D

D

11. While pulling the outer handle (A), remove the handle from the holes in the door panel. Take
care not to scratch the door.

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 8 sur 9

(2)

(1)

(4)

A

(3)

A

12. Remove the rod fastener (A) from the outer handle (B), then replace it with new one.

B

A

A

2011-04-02

Front Door Outer Handle Replacement - Without Super Locking

Page 9 sur 9

13. Install the handle in the reverse order of removal, and note these items:





Make sure the cylinder cable and each rod is connected securely.
Make sure the door key cylinder/door locks operate properly.
Make sure the door handle works properly.
When reinstalling the door panel, make sure the plastic cover is installed properly and
sealed around its outside perimeter to seal out water.

2011-04-02


Related documents


door06 1
book newcc   no logo1
digital door lock module actuators
variklis
60 72 chevy truck web
47 59 chevy truck web

Link to this page


Permanent link

Use the permanent link to the download page to share your document on Facebook, Twitter, LinkedIn, or directly with a contact by e-Mail, Messenger, Whatsapp, Line..

Short link

Use the short link to share your document on Twitter or by text message (SMS)

HTML Code

Copy the following HTML code to share your document on a Website or Blog

QR Code

QR Code link to PDF file door06.pdf