PDF Archive

CADENZA(VG) > 2014 > G 3.3 GDI >
Body (Interior and Exterior)

Replacement

Floor Console Replacement
• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to
prevent damage.
• Put on gloves to protect your hands.
1. Using a screwdriver or remover, remove the gear boots (B).
2. To remove the gear knob (A) and gear boots (B) pull both of it up.

3. Using a screwdriver or remover, remove the floor console upper cover (A).

4. Disconnect the connectors (A) from the floor console upper cover .

[Rear]

[Front]

5. Remove the console armrest tray (A).

6. Remove the console tray met (A).

7. Using a screwdriver or remover, remove the console side cover (A).

[LH]

[RH]

8. Disconnect the rear power outlet connector (A).

9. After loosening the mounting screws and bolts, then remove the floor console assembly (A).

10. Installation is the reverse of removal.
• Make sure the connectorare connected in properly.
• Replace any damage clips.

Console Armrest Replacement
• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to
prevent damage.
• Put on gloves to protect your hands.
1. Remove the floor console assembly.
2. After loosening the mounting screws, then remove the rear console cover (A).

3. After loosening the mounting screws, then remove the console armrest (A).

4. Installation is the reverse of removal.
• Replace any damage clips.