PDF Archive

Easily share your PDF documents with your contacts, on the Web and Social Networks.

Share a file Manage my documents Convert Recover PDF Search Help Contact

bt 7p6 golf VI .pdf

Original filename: bt 7p6 golf VI.pdf

This PDF 1.4 document has been generated by PDFUnlock! (http://www.pdfunlock.com) / iText® 5.5.2 ©2000-2014 iText Group NV (ONLINE PDF SERVICES; licensed version), and has been sent on pdf-archive.com on 07/01/2015 at 19:33, from IP address 77.113.x.x. The current document download page has been viewed 1022 times.
File size: 2.6 MB (7 pages).
Privacy: public file

Download original PDF file

Document preview


Product description
VW Bluetooth KIT

The installation is not so hard
VAS / VCDS Coding after installation required

Scope of delivery :

Bluetooth Module
Bluetooth Mic 3B0035711B
Foam Cover
Plug&Play Wiring




Use flat-head screwdriver to remove right
side cover.
Cover is simply mounted on latches, just
pull it out.

Use soft flat tool or
simply your nails to
lever frame around
Frame is mounted on
latches, carefully pull it




Unscrew four T20 screws mounting stereo.
Pull whole unit out.
Unplug power and antenna

– Insert a broach or rod above the glove compartment.
– Attach the black plug and small microphone plug to the rod and move it to the
right side of car.



Insert a flat head screwdriver under the passenger side doorstep cover
Raise the cover, it is mounted on few clips
Don't remove whole cover, it is not necessary

Remove small cover on the right side of car.
Pull out upper side and slide whole cover up.
Remove lower cover, pull it to the left side.


Raise up the carpet
Under the passenger seat should be a hole to insert wires

Plug in wires to the bluetooth module
Attach the module to the floor carpet.
Tie the wires to the existing ones and assemble removed covers



Remove Airbag cover from front passenger pillar and unscrew T25 bolt
Pull upper side of pillar cover to the left.
Don't remove whole piece cause it's hard to assemble

Pull down motion sensors cover
Unscrew two T20 bolts
Remove light panel
Insert microphone into its place before it, remove sponge.
Unscrew two T20 bolts




Put the microphone cable as shown on picture (red arrow).
Plug the wire into the microphone.
Assemble removed covers and screws.

Plug in the wires to the power plug behind stereo.
Assemble radio or navigation

Using VCDS add address 77 to the installation list in the CAN-Gateway module



Related documents

bt 7p6 golf vi
passport 300 pro service manual no diagrams
2017 canadian headlight conversion kit intalltion manual
bulletproof procedure
75138 ps dodge ram 2009 rev 20a
onboard monitor and navigation systems for e38 e39 e46 e53

Related keywords