CT 2060B CT 2080 User manual Jammers4u www.jammers4u.com .pdf

CT-2068B A, EUR, GPS
Briefcase cellular phone jamming system

User manual V.14.06

1

Foreword
This manual is the operating instructions of the CT-2068B Series jammer
(referred to as the “unit” in this manual).

The CT-2068B Series jammer is a jamming

device intended to prevent communications between mobile phones within a
designated area by jamming the downlink bands thereby disabling mobile handsets
receive capabilities.

Safety guidelines
Read the following guidelines before using the unit.
with these guidelines may be dangerous or illegal.

Failure to comply

In any event of doubt,

consult your local distributor or Vendor’s support staff before use.
Handling and transportation
Take maximum care while handling the unit.
Environmental conditions
Do not place the unit near heat sources.

The unit dissipates a lot of heat.

Never block its ventilation holes and do not insert any objects through them.
Always allow at least 10cm clearance in front of ventilation holes on two sides
for free air circulation
Qualified service
Only trained service personnel qualified by Vendor are allowed to diagnose
and maintain the unit in accordance with established safety practices and
standards.

2

Features
CT-2068B USA
( 8 Bands)

CT-2068B EUR
( 8 Bands)

CT-2068B GPS
( 8 Bands)

CT-2068B
( 8 Bands)

850-895MHz: 3W

130-180MHz: 3W

130-205MHz:
3W

920-965MHz: 3W

400-470MHz: 3W

1800-1990MHz: 3W

920-965MHz: 3W

2100-2170MHz: 3W

1800-1890MHz: 3W

WiFi
2400-2480MHz:1.5W

2100-2170MHz: 3W

4G LTE USA iPhone
(AT&T & Verizon)
700-800MHz: 2W
4G WiMAX USA Sprint
2500-2700MHz:1.0W

WiFi
2400-2480MHz:1.5W

GPS L1 1575.42
MHz±10MHz:
1.5W
GPS L2 1227.60
MHz±10MHz:
1.5W
GPS L3 1381.05
MHz±10MHz:
1.5W
GPS L4 1379.913
MHz±10MHz:
1.5W
GPS L5 1176.45
MHz±10MHz:
1.5W
920-965MHz: 3W
(850-895MHz)

4G LTE WiMAX2
Europe
2620-2690MHz: 1.0W
790-870MHz
4G LTE
Total: 19.0 W

1800-1890MHz:
3W
(1920-1990MHz)
2100-2170MHz:
3W
Total 16.5 W

GPS: L1 1575.42Mhz:
1.5W
Total: 18.0 W

205-275MHz:
3W
275-345MHz:3W

345-415MHz:
3W
415-500MHz:
3W
920-965MHz:
3W
(850-895MHz)
1800-1890MHz:
3W
(1920-1990MHz)
2100-2170MHz:
3W
Total: 24.0 W

Option: Remote/Alarm Control 315MHz, 433MHz, 868MHz, GPS L2 L3 L4 L5,, LoJack
173MHz,
SAT Sattellite Phones 1520-1670MHz, 11.a WiFi 5.1-5.5GHz, 5.5-5.9GHz, 3.5-3.7GHz
All Frequency can mix very Flexible, Each module/Band is independent
Adjustable Output Power each Band/Channel, Max Output Power to 0 (OFF)
Remote Control (Work when the case is close)
AC100-240V
Power supply:
Jamming Range

Radius10~40 meters (-75dBm@Omnidirectional antennas)

Weight
Dimension:
Contuine Using Time:

9.0Kg
430*350*120 mm
2-3 Hours, Can support use while battery charging
12V/20AH, 6A Battery Charger
210mm long for higher frequency / 380mm Long for
130-180MHz
1 year

Antenna
Warranty:

3

General Description
***NOTE***:
Make sure Connect all Antennas First

Main Power
ON/ OFF
AC 110-220V
Mode:
Remote / Manual

Remote Only may
Turn ON,
Can not Turn Off
(Interference
Remote Frequenc
Turn OFF Manual
Subpower
Switch

Adjustable Output Power Switch each Band

***NOTE***
*** Temperature Issue***
PCB-2068B 8 bands Continue
using (closed)

Extended the antenna
increase the remote
control distane

30 mins, Temperature is 60+
Degree C
60 mins, Temperature is 70+
Degree C
90 mins, Temperature is 80+
Degree C

A Button: Power ON
B Button: Power OFF

4

Altought it still work fine over 2
hours, we still recommend you
use in 1 hour (not so hot).

Operation
1, Connect all Antennas on the jammer

Connect all Antenans and
make sure it is tight

2,Turn Each band Adjustable Switch to Max(Clockwise to Max)
3, Turn the Jammer SubPower ON

Jammer SubPower ON

5

4, Turn the Main Power Switch ON
Main Power ON （Red Color)

Remote Option:
Use Remote Control to Turn ON/OFF Jammer
A Button: Power ON
B Button: Power OFF

Manual Option:

Manual ON
(Green Color)

Charging
1, Connect AC 110-220V

6

Use Battery Charge to charge the battery
 When battery is low, plug the Battery AC cable, one side to Charging In another
side to AC 110~220V. The LED of Charging (Red) will turn on , device is in
charging state.

LED is Two Red when the battery is
charging
Battery need 3-5 Hours to Full

 After about 3-5 hrs, Battery is 20AH and Charger is 6 A. Charger Indicator will
become “ Green”, indicating the battery had been 95% charged.

LED is Green
when the
battery is
full charging

R&R GROUP INTERNATIONAL
Taipei Taiwan, Hong Kong, Dubai UAE
E-mail: sales@shop-wifi.com
http://www.shop-wifi.com

7