This PDF 1.4 document has been generated by DL Pager V6.5 (158) Nov 16, 2005 / Adobe PDF Library 5.0.2, and has been sent on pdf-archive.com on 04/07/2015 at 21:12, from IP address 50.32.x.x.
The current document download page has been viewed 508 times.
File size: 173.12 KB (1 page).
Privacy: public file
501-19-1
Bumpers
501-19-1
REMOVAL AND INSTALLATION
Bumper Cover — Front
Removal and Installation
1.
5.
If equipped, disconnect the LH and RH fog
lamp electrical connectors.
6.
Remove the upper air deflector.
•
Remove the 3 lower air deflector pin-type
retainers.
•
Remove the 10 pin-type retainers.
Position the air deflector aside.
NOTE: Right side shown, left side similar.
2.
Remove the 2 front bumper cover lower
pin-type retainers.
3.
Remove the 4 LH and RH front fender splash
shield screws.
4.
Remove the 4 LH and RH front bumper
cover-to-fender bolts.
•
7.
Remove the 2 upper pin-type retainers for the
lower air deflector.
8.
Remove the 4 grille-to-radiator support bolts.
9.
Remove the front bumper cover.
10. To install, reverse the removal procedure.
To install, tighten to 11 Nm (8 lb-ft).
Copyright 2007, Ford Motor Company
Last updated: 6/7/2007
2008 Expedition, Navigator, 7/2007
expedition-grille.pdf (PDF, 173.12 KB)
Use the permanent link to the download page to share your document on Facebook, Twitter, LinkedIn, or directly with a contact by e-Mail, Messenger, Whatsapp, Line..
Use the short link to share your document on Twitter or by text message (SMS)
Copy the following HTML code to share your document on a Website or Blog