Mounting Guide for Velocity F one .pdf
Original filename: Mounting Guide for Velocity F-one.pdf
This PDF 1.5 document has been generated by Microsoft® Word 2013, and has been sent on pdf-archive.com on 03/08/2015 at 20:57, from IP address 213.65.x.x.
The current document download page has been viewed 295 times.
File size: 2.6 MB (10 pages).
Privacy: public file
Download original PDF file
Mounting Guide for Velocity F-One 250 size racing quad.
1. Start by mounting the 8pcs M3x35mm aluminum screws in the wholes of the bottom and top chassi
plate and just enter the nyloc nuts slightly. And pull apart the plates.
2. Mount the middle arms by clicking them in the slots and be sure to put them the right way so you get the
mounting tabs (yellow) for the controller with the O-rings facing the bottom plate.
Make sure to you don’t overtight the chassi screws, there is no need for high torque.
Make sure to get the thickest motor plate and mount it in the bottom so the thinnest goes right under
We usually only mount 3 s crews in the motor but 4 is included, in race every gram counts.
Make small loops like the picture with the O-rings and mount on the tabs that you know should have mounted all
in the same way.
Some mountingt tips for the escs.
A tip on power ditribution, here we have used 2mm brass tubes and solderd 3 pcs together.
If you use 3 brasstubes for + and 3 for - you get extra slots where you can plug in VTX and ledlights or
whatever you want.
The velcro and some overall pictures.