Aluminum Surface Sandblasting Technology .pdf
Original filename: Aluminum Surface Sandblasting Technology.pdf
This PDF 1.7 document has been generated by WPS Office / , and has been sent on pdf-archive.com on 10/03/2016 at 02:50, from IP address 173.82.x.x.
The current document download page has been viewed 394 times.
File size: 120 KB (2 pages).
Privacy: public file
Download original PDF file
Aluminum Surface Sandblasting Technology
With the rapid development of the domestic industrial and infrastructure investments，
the aluminiumprofile industry also increases rapidly. After ten years rapid
development, the aluminum industry has entered to a new stage. For aluminum, the
surface sandblasting process will be a new trend.
Aluminum surface sandblasting technology has been widely applied, mainly used in
automobile manufacturing, rail transportation, machinery and equipment
manufacturing, and other industrial fields. Sandblasting process technology does good
effect on aluminum surface hardness adjustment and bulk density. It is no free
silica,environmentally friendly and with good toughness.
Aluminum sandblasting process is the use of high voltage electrostatic field corona
principle. Connect the gun head-a part of aluminum sandblasting process tool to the
negative high voltage. Then have the coated work piece connected with ground to
form positive electrode. So there will be a strong static electric field produced
between the gun and the work piece.
When the carrier gas-compressed air transmit the powder coating to the gun rod
diversion from the powder barrel,there will be densive negative charge around the
powder, for the connected diversion rod produce high voltage. After the powder enter
Tel:+86 137 5017 8582
into the electrostatic field, under the double effect of static electricity and gas carrier,
they will be sprayed on the ground surface evenly while forming well-distributed
powder layer. Next, heating and solidifying the powder layer into a durable coating.
The general construction process of aluminum surface sandblasting technology:
pre-treatment, drying to remove water, spraying ,check, baking, check-finished.
There are various abrasive material such as iron ore, steel grit, ceramic sand, alumina,
quartz sand, silicon carbide, etc. Abrasive material should be choosed according to the
aluprofile surface and production requirements.
Tel:+86 137 5017 8582