BlueOptics BO01C13210 1000BASE LX GBIC.pdf


Preview of PDF document blueoptics-bo01c13210-1000base-lx-gbic.pdf

Page 1 2 3 4 5 6 7

Text preview


BO01C13210
GBIC 1.25G 1310nm 10KM
RoHS Compliant Optical Transceiver

5. Receiver Specifications - Optical
Parameter
Input Optical Wavelength
Receiver Sensitivity
Input Saturation Power (Overload)
LOS Assert
LOS De-assert
LOS Hysteresis

1.

Symbol

λIN
PIN
PSAT
PA
PD
PA-PD

Min.
1270

Typ.

Max.
1610
-19

-3
38
0.5

2.0

-20
6.0

Unit
nm
dBM
dBm
dBm
dBm
dB

Note
1

Notes:
-12
7
Measured with Light source 1310nm, ER=9dB; BER =<10 @PRBS=2 -1 non-return-to-zero.

6. GBIC to Host Connector Pin Out
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20

1.
2.

3.

Symbol
VEET
TFAULT
TDIS
MOD_DEF(2)
MOD_DEF(1)
MOD_DEF(0)
RS0
LOS
VEER
VEER
VEER
RDRD+
VEER
VCCR
VCCT
VEET
TD+
TDVEET

Name / Description
Transmitter Ground (Common with Receiver Ground)
Transmitter Fault indication
Transmitter Disable
Module Definition 2. Data line for Serial ID.
Module Definition 1. Data line for Serial ID.
Module Definition 0. Data line for Serial ID.
Rate Select 0
Loss of Signal indication
Receiver Ground (Common with Transmitter Ground)
Receiver Ground (Common with Transmitter Ground)
Receiver Ground (Common with Transmitter Ground)
Inv. Received Data Out
Received Data Out
Receiver Ground (Common with Transmitter Ground)
Receiver Power Supply
Transmitter Power
Transmitter Ground (Common with Receiver Ground)
Transmit Data In
Inv. Transmit Data In
Transmitter Ground (Common with Receiver Ground)

Notes:
Circuit ground is internally isolated from chassis ground.
TDis is an input that is used to shut down the transmitter optical output. It is pulled up within the
module with a 4.7k~10kΩ resistor. Its states are:
Low (0 to 0.8V): Transmitter on
(>0.8V, < 2.0V): Undefined
High (2.0 to 3.465V): Transmitter Disabled
Open: Transmitter Disabled
Mod-Def 0,1,2. These are the module definition pins. They should be pulled up with a 4.7k~10kΩ
resistor on the host board. The pull-up voltage shall be VccT or VccR.
Mod-Def 0 is grounded by the module to indicate that the module is present
Mod-Def 1 is the clock line of two wire serial interface for serial ID
Mod-Def 2 is the data line of two wire serial interface for serial ID

-4-

Note
1
2
3
3
3
4
1
1
1

1

1

1