StopTech Caliper Fitment .pdf
Original filename: StopTech Caliper Fitment.pdf
Title: 98-442-2430-00 - Sheet1
This PDF 1.5 document has been generated by PScript5.dll Version 5.2.2 / Acrobat Distiller 9.2.0 (Windows), and has been sent on pdf-archive.com on 31/08/2016 at 01:27, from IP address 172.56.x.x.
The current document download page has been viewed 587 times.
File size: 302 KB (2 pages).
Privacy: public file
Download original PDF file
StopTech Caliper Fitment.pdf (PDF, 302 KB)
Share on social networks
Link to this file download page
WHEEL FITMENT INSTRUCTIONS
1. Print a copy of the drawing,
making sure that the “Page Scaling”
is set at “none.” (or make sure
“Scale” is at “100%”)
4. Glue the drawing to a stiffer piece
of material such as a manila folder to
make the template easier to use.
Finish by cutting directly along the
2. Check dimensions both vertically
and horizontally to confirm it has
been printed to scale.
3. Cut the drawing just outside the
5. Lay the template inside the wheel
6. Verify that the edge of the caliper
does not touch the rim or the wheel
spokes. A minimum clearance of
2mm (0.080”) is recommended.
If there is interference, different wheels or a spacer will be necessary. Use of a wheel spacer is at the discretion of the
vehicle owner. Typically a properly made spacer of 2‐3mm will not adversely affect the vehicle. Issues that must be
addressed before utilizing a wheel spacer include, but are not limited to, fender clearance, proper wheel bolt or stud
length, effect on vehicle handling, and centering of the wheel. Wheel fitment and the use of wheel spacers with our big
brake upgrades is the responsibility of the customer.
If you have any questions, please e‐mail firstname.lastname@example.org or call +1 310‐933‐1100.
This outline is the net dimension
of the brake system. STOPTECH
recommends adding 2mm of
clearance to these dimensions.
1. Verify accuracy of printout by matching a
dimension in both length and width. One
dimension in each direction is shown in both inch
and mm. All other dimensions are mm.
BRAKE KIT OUTLINE
HONDA CR-Z '11+
FRONT 328x28 - ST40M
2. Cut along dashed line to use as template.
Link to this page
Use the permanent link to the download page to share your document on Facebook, Twitter, LinkedIn, or directly with a contact by e-Mail, Messenger, Whatsapp, Line..
Use the short link to share your document on Twitter or by text message (SMS)
Copy the following HTML code to share your document on a Website or Blog