License Plate Instructions SNS 3b 2007 Mustang PJ Saleen.pdf


Preview of PDF document license-plate-instructions-sns-3b-2007-mustang-pj-saleen.pdf

Page 1 2 3 4 5 6 7

Text preview


Warning: Please read directions completely before starting. If you have any
questions please contact BMPP before beginning your installation. Also please
check our website (bigmikesperformanceparts.com) for any updates or changes.
Thank You.
Parts Included:

License Plate mounting bracket Assembly. Includes Base Plate and
License Plate Holder.
License Plate mounting Screws: (2) 6mm X 16mm (Phillips head), (2)
6mm nuts with lock washers (10mm wench size)
Base plate mounting screws: (2) 4.2mm X25mm screws (2) 6.3mmX20mm
with washer, and 6mmX20mm bolts and nuts.

Tools Needed:

7/32, 7mm, 8mm & 10mm sockets with ratchet Note: 1/4 inch drive
preferred but 3/8 will work (but extra caution will be needed when
tightening screws)
Phillips screwdriver & 10mm wrench
1/8 and 1/4" inch drill bit and drill.

Step 1: Insure all parts listed above are accounted for. Note: If at any time during the
installation process you need assistance please call (831)663-4849.
Step 2: Separate the license plate holder from the base by simply pulling the pull pin ring
outward and sliding apart.
Step 3: Remove the two center spoiler screws (4mm) using a 7/32 socket and ratchet. See
figure 1 for location.
Step 4: Now position the base mount with the two holes towards the front of the car, centered
over the two holes where the two 4mm screws was just removed. Note: Tube will be facing
down. Using the (2) 4.2mm X 25mm screws secure the base plate in place. See figure 2
Step 5: Once base plate is secured using the two front mounting holes, carefully drill two pilot
holes for the rear mounting screws. Note: If the vehicle is equipped with a lower grille drill
two 1/8" pilot holes and secure using 6.3X20mm screws. If vehicle is not equipped with lower
grille drill two 1/4" holes and secure with 6mm bolts and nuts. : See figure3.
Step 6: Using either the two 6.3X20mm screw, or 6mm bolts and nuts, secure the rear of base
plate to the vehicle using the following method. Caution: When tightening the screws extreme