Honda Ridgeline 2017 Adapter Rails Installation Instructions .pdf

SUPPLEMENT TO TONNEAU INSTALLATION INSTRUCTIONS
2017 Honda Ridgeline
Tools Required:
T50 Torx driver
7/16” Wrench
Remove the 4 upper tie-down hooks. Keep the 8 Torx bolts, but do not reuse the tie-down hooks.
Front, upper tie-down hooks.
Both sides.

Rear, upper tie-down hooks.
Both Sides.

Align the parts for assembly as shown.
Tail Bracket Mount
Right,
27002012
Honda Ridgeline Accessory Rail Right
15003102

(Notch is at the
tailgate end)

Screws, 1/4-20 x 3/4LG S.H.C.S
25000800
Accessory Bracket Mount, 22000100

Honda Ridgeline Accessory Rail Left
15003104

Cab Bracket Mount, 27002010
(notice the slotted holes are on the top)
Tap Plate, 22000000

Truck Hero
5400 S. State Road
Ann Arbor, MI 48108
734 677-0444, Fax: 734 677-8409

Tail Bracket Mount Left, 27002014

Register your warranty at:

Truck-Hero.com
3 1 8 3 0 0 0 4 - 3 0

I t e m N o . 3 1 8 3 0 0 0 4 - 3 0 - 1 6 0 9 DD
Truck Hero Inc. 2016 Printed in U.S.A.

Slide two of the accessory bracket mounts into
each rail. Align with the rail interior prole
as shown.

Slide one accessory bracket mount to the front, leaving
the other at the tailgate end of the rail.

(Notch is at the
tailgate end)

With the accessory bracket mounts slid into the rails, assemble the brackets as shown. Loosely tighten the screws.
Accessory Rail Left

Accessory Rail front, copied on left and right

Tap Plate

Accessory Rail Right

Screws

Screws

Accessory
Bracket
Mount

Tap Plate

Accessory Bracket Mount

Tap Plate

Cab Bracket Mount
(notice the slotted holes are on the top)
Tail Bracket
Mount Left

Tail Bracket
Mount Right

With the brackets mounted to the rails, place the rails on the truck. Position the rail so the front
cap pad rmly contacts the bulkhead. Align the brackets so that they line up with the
factory tie-down hook bolt holes, then thread in the factory bolts and tighten.
Tighten the front hardware while pushing down on the rail to make good seal contact
Cap pad
with the truck bed at the same time also pushing the rail forward to keep good
to bulkhead
contact between the cap pad and bulkhead.
Continue to push down on the rail while tightening
the rear bracket hardware.

A
B

Tighten both Torx bolts,
then tighten both Allen
head bolts.

Push down

Tighten both Torx bolts,
then tighten both
Allen head bolts.
Push down

2
2

1

1

Truck Hero Inc. 5400 S. State Road Ann Arbor, MI 48108 734 677-0444, Fax: 734 677-8409

Visit us at truck-hero.com