This PDF 1.5 document has been generated by Microsoft® Word 2010, and has been sent on pdf-archive.com on 05/03/2017 at 09:44, from IP address 85.203.x.x.
The current document download page has been viewed 626 times.
File size: 978.51 KB (7 pages).
Privacy: public file
CT-3076-HGA
Anti-Drone Jamming System with Higher Gain Antenna User Manual
Foreword
This manual is the operating instructions of the CT-3076-HGA jammer (referred to as the “unit” in this manual).
The CT-3076-HGA
Series jammer is a jamming device intended to prevent all Drone UAVs. The unit outputs 2-40W for each of the Six bands (2 x
2400-2500MHz WiFi: 20W, 2 x GPS L1 1570-1620MHz: 40W. 2 x 5.8GHz:2W )
Safety guidelines
Read the following guidelines before using the unit.
Failure to comply with these guidelines may be dangerous or illegal.
In any event of doubt, consult your local distributor or Vendor’s support staff before use.
Handling and transportation
Take maximum care while handling the unit.
Environmental conditions
Do not place the unit near heat sources. The unit dissipates a lot of heat.
any objects through them.
Never block its ventilation holes and do not insert
Always allow at least 10cm clearance in front of ventilation holes on two sides for free air
circulation
Qualified service
Only trained service personnel qualified by Vendor are allowed to diagnose and maintain the unit in accordance with
established safety practices and standards.
Features
Jamming frequency (it may change)
CH1: 5.7-5.8GHz:2W
Ch2: GPS L1 1570-1620MHz: 40W
CH3: WiFi 2400-2500MHz: 20W
***NOTE***:
CH4: 5.7-5.8GHz 2W
Before you turn on the jammer, please………..
CH5: GPS L1 1570-1620MHz: 40W
Make sure connect all Antennas to the jammer
CH6: WiFi 2400-2500MHz: 20W
The input power applied from 110V or 220V AC.
Step 1: Open the case
CH6: 2400MHz
CH5: GPS L1
Unscrew these
two screws to
open the caser
CH4: 5.8GHz
CH3: 2400MHz
CH2: GPS L1
CH1:5.8GHz
Step 2: Connect all Antennas:
CH1 to Antenna CH1, CH2 to CH2....
***NOTE***:
Before you turn on the jammer, please………..
Make sure connect all Antennas to the jammer
Connect all Antennas
CH1 to Antenna CH1
CH2 to Antenna CH2
.....
.......
Ch6 to Antenna CH6
Step 3: Connect AC Power Cord.. and Switch each band output power to Max...
Switch ON each band
Clockwise to Max
From Off to Max Output
Power
Switch ON each band
Clockwise to Max
From Off to Max Output
Power
CT-3076-HGA Outdoor Drone Jammer user manual (1).pdf (PDF, 978.51 KB)
Use the permanent link to the download page to share your document on Facebook, Twitter, LinkedIn, or directly with a contact by e-Mail, Messenger, Whatsapp, Line..
Use the short link to share your document on Twitter or by text message (SMS)
Copy the following HTML code to share your document on a Website or Blog