PDF Archive

Easily share your PDF documents with your contacts, on the Web and Social Networks.

Share a file Manage my documents Convert Recover Search Help Contact



DEVRY ECET 340 Week 7 HomeWork 7 .pdf


Original filename: DEVRY ECET 340 Week 7 HomeWork 7.pdf
Author: Minu

This PDF 1.5 document has been generated by Microsoft® Office Word 2007, and has been sent on pdf-archive.com on 10/03/2017 at 06:58, from IP address 43.224.x.x. The current document download page has been viewed 71 times.
File size: 338 KB (2 pages).
Privacy: public file




Download original PDF file









Document preview


ECET 340 Week 7 HomeWork 7

Check this A+ tutorial guideline at
http://www.assignmentcloud.com/ecet-340devry/ecet-340-week-7-homework-7
1. The movable part of the solenoid is the: +2 points
2. Why is the 6N139 optoisolator used in the interfaces to devices such as large motors? +2
points
3. Calculate the number of steps per revolution for a stepper motor with a step angle of
7.5°. +2 points
4. How is stepper motor speed controlled? State any two ways a program can do this. +2
points
5. For this problem, you should look at Figure 5A on the next page as a physical example of
a stepper motor. It is an example of a stepper motor with four (4) magnetic windings which
are connected via an interface circuit to the HCS12 Port T pins 4, 5, 6, & 7, with an
armature (rotor) that has 12 poles (combined number of North and South magnetic poles).
Notice how each step rotates the rotor 30 degrees, and notice the logic states on the Port T
pins going from Step 1 to Step 2. To rotate the rotor 90 degrees, you would need three (3)
steps (see figure 5A for explanation).
6. Identify 2 major kinds of devices that can be used to interface a dc motor to the HCS12.
+2 points
7. Given that pulses need to be delivered to a specific dc motor at the rate of 12.5 kHz to
avoid vibration, write down the C statements needed to output pulses from the HCS12 to
drive the at 80% of its full drive level. +2 points
8. An HCS12 timer input capture/output compare register (TC0) holds the value 0x498
when timing the period between pulses coming in from a servomotor’s optical encoder (see
Figure 8A below for setup of optical encoder). Assume the counter/timer is operating at

1.0us. The encoder wheel has 6 holes. Find the motor’s speed in RPM. Show work. +2
points
9. Unidirectional dc motors often have high-voltage diode connected for reverse-bias across
the motor’s input terminals. Explain why this is done. +2 points
10. What advantages do dc motors offer over stepper motors? +2 points

For more classes visit

http://www.assignmentcloud.com


DEVRY ECET 340 Week 7 HomeWork 7.pdf - page 1/2
DEVRY ECET 340 Week 7 HomeWork 7.pdf - page 2/2

Related documents


PDF Document devry ecet 340 week 7 homework 7
PDF Document devry ecet 340 week 7 homework 7
PDF Document global closed loop stepper motor market
PDF Document 38i15 ijaet0715660 v6 iss3 1355to1364
PDF Document stepper motor market size
PDF Document copper and motor efficiency


Related keywords