PDF Archive search engine
Last database update: 17 November at 11:24 - Around 76000 files indexed.

Show results per page

Results for «configure»:

Total: 800 results - 0.018 seconds

ComTrafic PABX 98%

= Si possible un accès Internet pour d'éventuelles mises à jour 2.2 Configuration du PABX Le 'Gestionnaire de taxes' du PABX doit être configuré de la manière suivante, via le logiciel de configuration AMS :


ICHNE 16 Months 98%

The Concept of Electricity, electronics components and its uses, Rectification Digital Electronic concept and components Fundamental of operating system and pcs hardware To assemble, configure and troubleshoot pcs / Laptops Troubleshoot and Repair Various Computer Part Like Mother Boards, All kind of Printers, TFT/LCD Monitors , Mobile Phones and Laptops To setup and configure a Heterogeneous network To configure and manage wireless networks To Setup configure and manage Windows Server 2008 Network To Setup configure and manage the WAN using Cisco Devices To configure and Manage Cisco Devices.


DNS Configuration of Cisco Router as DNS Server (1) 97%

UNCLASSIFIED Configuring the Router as a DNS Server Perform this task to configure the router as a DNS server.


Network Lab Manual-Configuration-all 96%

Compute Network LAB – 1 Manual S Main Topic 1 Hardware 2 PT – PC2PC 3 PT – Switching 4 PT – Wireless 5 6 7 PT – Server PT – Server PT 8 PT Router Configuration 9 PT Router Information 10 PT - Routing 11 Windows - Commands 12 Content NW Hardware’s Straight-Over Cable Cross-Over Cable Connect to PCs through a cross-over cable Static IP Address Use Hub in NW Use Switch in NW Wireless Access Point Join two AP to a LAN by SW Authentication in Wi-Fi NWs Save the Project DNS-Server DHCP-Server All in One >enable #configure terminal Interface Assigning IP Address ()#interface fastethernet 0/0 (int)#ip address (int)#no shut ()#router rip version 2 network network #write memory Show Commands >enable #show ip interface #show ip interface brief Use two Routers Two Different Subnets at the ends of Routers Windows Trouble Shooting Commands :


Zeus-Crimeware-Toolkit 95%

Zeus Crimeware Toolkit Author:


Practice V2.1 93%

In the Getting Started Wizard click Configure network settings.


VOICE Complete 92%

Exclude any necessary IP addresses Create DHCP Pool Define network Define default router (gateway) Define DNS settings Configure IP Helper-Addresses, if necessary.


ASIO4ALL v2 Instruction Manual 92% - ASIO4ALL Web site - Support forum Getting Started Setting up your audio software In order to make use of ASIO4ALL, you need to configure your audio software accordingly.


Apple Configurator 2-Method1 92%

Once we have the general tab set up, go configure the WiFi payload with the users WiFi settings (Figure 9).


duster 92%


LT-Xtream-codes-Billing-Panel 91%

Page 2 of 15 LT Televi sion Xtream-Codes WHMCS module by LT Television - 1.7 Installation • Unzip the module package and upload entire xtreamcodes folder to whmcsdir/modules/servers • To check ioncube version used in your server open whmcsdir/modules/servers/xtreamcodes/ configure/ioncube.php in your web-browser • Default panel version for WHMCS module is v2, if you use v1 then edit config.php ◦ $panel_version 1 is for v1 and 2 is for v2 • Expiredates for streaming lines are not needed in whmcs, since whmcs controls everything (enable,disable,terminate) • As of module version 1.7 you can use expiredates if you wish, enable them in config.php (default is OFF) • Go to WHMCS admin home page ◦ You should see module info there, make sure license is ok, do not proceed if its not ok, instead contact developer.


pi-hole[1] 91%

Configure the static IP address.


B&W DB Series Brochure 91%

An intuitive control app makes them simple to configure and use, whether they are being used in a cinema system, a home installation or to complement stereo loudspeakers.


DR update 16June2016 91%

DRs by Priority &